gCreate contacted me and had a solution for the 3d part OpenRC F1 axle. I stopped by while in New York to see what they had, and what else they were printing. On the machine was some Matterhackers PRO PLA and NylonX! ==== I use MatterHackers for everything 3D printing, and they even help support […]
3D Printing Bearing Shapes for the World’s Largest OpenRC F1 RC Car [EDIT: Its a Bushing]
EDIT – Yes, it’s a bushing. No, I’m not worried about lubrication or friction. Have a look at the pinned comment. The question I’ve been asked the most is what am I going to use for bearings in the 4x scale OpenRC F1 project. Finding the proper sized bearings was going to take more time […]
Worlds Largest OpenRC F1 Car – Phase 2 // Gluing The Parts w/ Bill from Punished Props Academy
I needed to get some of the OpenRC parts glued, and I knew Bill Doran of Punished Props Academy would be the best person to help out with this. Bill and I used a urethane adhesive from BJB Enterprises, as well as 5 minute epoxy and superglue. Yes, the video is LONG, but, anytime Bill […]
Worlds Largest OpenRC F1 Car – Phase 1 // 3D Printing the Parts (Matterhackers BUILD PLA / Pro Flex)
The OpenRC F1 fully 3d printed remote controlled car is a project by Daniel Noree. The idea is to print all the pieces needed for the car, then add electronics, to have yourself a custom built rc car. I took it a step further and printed everything at 4x scale! 1,113 HOURS OF PRINTING 47 […]